How to Build a Smok Pen
The Smok Pen is really a revolutionary vaporizing pen which allows for a write-to-write experience, whilst you are abroad. This is because of the unique design of the pen. It has two tanks, one smaller than the other, that house the e juice and charged batteries. Once the user wants to write, he just places the pen into the smaller tank and places the ink in the chamber where it will be vaporized. He simply turns on the pen and writes as if he is writing under a black mirror.
One of the greatest attributes of the Smok Pen is its ability to charge while it is on your own desk. It is because the coils on the Smok Pen were created in a way to keep the e juice from dripping onto the table or somewhere else. This is because of the 0.3-ohm coil that is placed inside the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents will not affect the writing process. The reason being the electronic circuitry has protection built in so that it will not be suffering from extremely low voltage electric currents.
The Smok Pen can be charged internally with a charger or via the USB connection that is included with it. Since the electronic circuitry includes a safety barrier built in, this means that there is absolutely no risk involved when charging the device through the computer. The Smok Pen includes a charging capacity of sixteen 50 mah batteries, that is ideal for all pens that use one or two batteries.
In order to keep the Smok Pen working for an extended time period it is important you don’t overcharge the battery. Overcharging the battery will reduce the voltage that is available and may eventually result in these devices malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. In the event that you feel that your battery isn’t getting the vapor it should, remove the pen from the power source and let it cool down for a few minutes.
The fire button on the Smok Pen is located at the bottom right corner of these devices. The fire button comes with an orange light, which indicates that it’s on. It is possible to press this button to activate the electronic heating element that may let you vaporize the oil. When you have done so you can take away the coil from the holder and stick it in to the holder and place the Smok Pen in to the airflow chamber, that will cause the heating element to start out heating up and burning off the wick.
Once the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are put inside the holder plus they get heated from the airflow. After they get hot they start to turn blue, that is the indication that it’s ready for the pen’s battery. Ensure that you place your sub-ohm into the chamber before you push the fire button. If you don’t put the coil in to the airflow chamber then the oil will leak and cause the leaking of e-juice.
Before you put the battery into the pen, you must make sure that you have disconnected all of the leads. Then you have to take out the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a little cotton bud, to enable you to get rid of the leak. Then reattach the cap back to the Smok Pen and you also are ready to place the battery into the pen.
The final part of the Electric Tobacconist construction process is the adapter plate, which fits in to the Smok Vaporizer’s USB port. This plate permits you to charge your e-juice through your computer, as long as you have an adapter for USB connection. I really like this part as it allows me to charge my entire kit at once without fretting about running out of power or constantly running out of e-juice.